China Water Treatment (John Guest) Fittings, Plastic Water Treatment Push-In Fittings Supplier

Location: Home > Push To Connect Fittings > Water Treatment Fittings

Water Treatment Push-In Fittings (Plastic)

Plastic Water Treatment System Fittings

Interchange With John Guest Fittings (Drinks Dispense And Pure Water Fittings)

Features

■ Simply & Fast to install & uninstall with no tool.
■ Suitable for soft metal & plastic tubes.
■ Applied to pure water and potable liquids systems.
■ Reuseable-Can be assembled and disassembled repeatedly.(recommend to cut the surface-damaged part of tube).
■ For inert liquids & gases. Perfect performance for drinks dispense and pure water system.

Specification

Temperature Range	-20°C to +70°C
Working Pressure Max	10 bar
Media	Inert liquids & gases

Note:
■ Depending on the tube used, under certain conditions fittings may be used at higher pressures and temperatures.
■ They should be replaced once appear damaged, cracked, charred, discoloured, heat distorted or corroded. Any product that is or appears to be leaking should be replaced.
■ Product life is affected by the severity of the application, It is needed to set specific replacement intervals.

Installation Instructions

To connect tube (see figure 1)

■ Cut tubing squarely–maximum of 15° angle allowable. Use of tube cutter (PTC) is recommended.
■ Check that port or mating part is clean and free of debris.
■ Insert tube into fitting until it bottoms.Push twice to verify that tubing is inserted past collet & O-Ring.
■ Pull on tubing to verify it is fully inserted.

figure 1

To disconnect tube (see figure 2)

■ Simply press release button, hold against body, and pull tubing out of fitting.

figure 2

Click Here For Overview Of Plastic Water Treatment Push-In Fittings

Page <1> <2>

Related Products

>>> Plastic Push In Fittings

>>> Brass Push In Fittings

>>> Stainless Steel Push In Fittings

>>> Compact Push In Fittings

>>> Pneumatic Accessories - Silencer/Muffler, Flow Controller, Air Gun, Check Valve, Tube Cutter